1.png)
Solar Tracker Elektro-Pneumatik Berbasis Kendali Fuzzy
Sari
ABSTRAK
Salah satu faktor yang mempengaruhi daya keluaran listrik dari panel surya adalah posisi dan tingkat penyerapan sinar UV (Ultraviolet) dari matahari. Penggunaan aktuator motor servo untuk solar tracker membebani listrik yang dihasilkan dari pembangkit internal panel surya. Pada penelitian ini dirancang solar tracker menggunakan silinder pneumatik sebagai pengganti aktuator motor servo. Sedangkan, sensor UV digunakan untuk memantau sudut pergerakan matahari. Nilai error dan Δerror dari hasil pengolahan data sensor UV menjadi masukan bagi sistem pengambilan keputusan berbasis kendali fuzzy. Keluaran sistem pengambilan keputusan ini mengatur pergerakan posisi silinder pneumatik naik, turun, atau stop. Pengujian perangkat bekerja dengan baik, menghasilkan respon dinamik overshoot 5,3 % dan error steady state 1,6 %.
Kata kunci: ultraviolet, pneumatik, fuzzy, overshoot, error
ABSTRACT
One of the factors that affect the electrical output power of solar panels is the position and the absorption level of UV (Ultraviolet) rays from the sun. The use of a servo motor actuator for solar trackers burdens the generated electricity from the solar panels internal generator. In this study, a solar tracker was designed using a pneumatic cylinder as a replacement for the servo motor actuator. While a UV sensor was used to monitor the angle of the sun’s movement. The error and Δerror values from UV sensor data processing results become an input for decision-making systems based on fuzzy control. The output of this decision-making system regulates the movement of the position of the pneumatic cylinder up, down, or stopping. The test device worked properly, resulting in a dynamic response overshoot of 5.3% and a steady-state error of 1.6%.
Keywords: ultraviolet, pneumatic, fuzzy, overshoot, error
Kata Kunci
Teks Lengkap:
PDFReferensi
Smirnov, A.A., Vozmilov, G., and Romanov, P.A., (2019). "Comparison of Discrete Sun Tracking Methods for Photovoltaic Panels", International Conference on Industrial Engineering, Applications and Manufacturing (ICIEAM), Sochi, Russia, pp. 1-5.
DÃaz, A., Garrido, R., and Soto-Bernal, J.J., (2019). "A Filtered Sun Sensor for Solar Tracking in HCPV and CSP Systems", in IEEE Sensors Journal, 19, pp. 917-925.
Rouzbeh, B., Bone, G.M., and Ashby, G., (2018)."High-Accuracy Position Control of a Rotary Pneumatic Actuator", in IEEE/ASME Transactions on Mechatronics, 23, pp. 2774-2781.
Rahmanian, E., Akbari, H., and Sheisi, G.H., (2017). "Maximum Power Point Tracking in Grid Connected Wind Plant by Using Intelligent Controller and Switched Reluctance Generator", in IEEE Transactions on Sustainable Energy,8, pp.1313-1320.
Jabr, H.M., Lu, D., and Kar, N.C., (2011). "Design and Implementation of Neuro-Fuzzy Vector Control for Wind-Driven Doubly-Fed Induction Generator", in IEEE Transactions on Sustainable Energy,2, pp. 404-413.
Chern, T., et al., (2014). "Excitation Synchronous Wind Power Generators With Maximum Power Tracking Scheme", in IEEE Transactions on Sustainable Energy, 5, pp. 1090-1098.
Cui, Z., Song, L., and Li, S., (2017). "Maximum Power Point Tracking Strategy for a New Wind Power System and Its Design Details", in IEEE Transactions on Energy Conversion, 32, pp. 1063-1071.
Lin, Z., Zhang, T., Xie, Q., and Wei, Q., (2018). "Intelligent Electro-Pneumatic Position Tracking System Using Improved Mode-Switching Sliding Control With Fuzzy Nonlinear Gain", in IEEE Access, 6, pp. 34462-34476.
Amelia, A.R., et al (2019). "Technologies of solar tracking systems: A review", IOP Conf. Series: Materials Science and Engineering 1st International Symposium on Engineering and Technology (ISETech), 767, pp. 1-10.
Smirnov, A.A., Vozmilov, G., and Sultonov. O.O., (2018). "Investigating t he Effectiveness of Solar Tracking for a PV Facility in Chelyabinsk", Int. Conf. On Industrial Engineering, Application and Manufacturing.
Hamid, A.R., Azim, K., and Bakar, M.H., (2017). "A review on Solar Tracking System", e-Proceeding National Innovation and Invention Competition Through, pp 1-9.
Smirnov, A.A., Malugin, S.A., and Bakanov, A.V., (2017). "Designing Integrated PV Facility with Dual-axis Solar Tracking System Mounted on the South Building Face", Int. Conf. On Industrial Engineering, Application and Manufacturing, pp. 1-4.
Sumathi, V., Jayapragash, R., Bakshi, A., and Akella, P.K., (2017). "Solar Tracking Methods to Maximize PV System Output – A review of the Methods Adopted in Recent Decade", Renewable and Sustainable Energy Reviews, 74, pp. 130-138.
DOI: https://doi.org/10.26760/jrh.v4i3.179-190
Refbacks
- Saat ini tidak ada refbacks.
Alamat redaksi dan tata usaha:
Lembaga Penelitian dan Pengabdian Masyarakat Institut Teknologi Nasional
Fakultas, gedung 14 Lantai 3
Jl. PHH. Mustapa 23 Bandung 40124
Tlp. 022-7272215 Pes. 159, Fax. 022-7202892,
e-mail: hrekayasa@itenas.ac.id
Terindeks:
Jurnal ini terlisensi oleh Creative Commons Attribution-ShareAlike 4.0 International License.
