Lithium-ion Battery Charger for BEV Applications Based on MF Full-bridge DC-DC Converter

BUDHI ANTO, DAFA BAGUS PRATAMA

Sari


ABSTRAK

Artikel ini memaparkan rancang bangun suatu alat pengisi muatan baterai (battery charger) kendaraan listrik jenis lithium-ion. Baterai yang digunakan berkapasitas 20-Ah dengan tegangan pengenal 48-V. Rangkaian battery charger menggunakan susunan kombinasi dari konverter AC-DC topologi penyearah satufasa jembatan dioda dan konverter DC-DC topologi jembatan-penuh yang dioperasikan pada frekuensi menengah (MF) yaitu sebesar 1 kHz. Rangkaian konverter jembatan-penuh dikendalikan oleh IC SG3526 yang mengatur lebar pulsa sinyal PWM yang diberikan kepada keempat MOSFET yang menyusun konverter tersebut. Karena dioperasikan pada frekuensi 1 kHz, konverter jembatan-penuh dapat menggunakan transformator yang intinya berbahan baja silikon berbentuk pelat tipis terlaminasi atau lebih dikenal dengan inti pelat E-I. Pengujian fungsional alat dilakukan dengan mengisi muatan baterai pada keadaan kapasitas awal 50% hingga penuh, menggunakan metode arus pengisian tetap sebesar 5-A. Hasil pengujian memperlihatkan bahwa diperlukan waktu 80 menit untuk mengisi baterai hingga penuh pada kondisi tersebut.

Kata kunci: alat pengisi muatan baterai lithium-ion, kendaraan listrik, full-bridge DC-DC converter, frekuensi menengah, transformator inti baja silikon

 

ABSTRACT

This manuscript describes the designing and making of a lithium-ion battery charger for battery electric vehicle applications. The battery has a capacity of 20-Ah with 48-V nominal voltage. The battery charger circuit uses the combination of an AC-DC converter in the form of a single-phase diode bridge rectifier and a full-bridge DC-DC converter, operating in medium frequency (MF) at 1 kHz. The full-bridge converter is controlled by a PWM controller SG3526 that sends its output to the 4 MOSFETs that built the converter. Due to operation at frequency of 1 kHz, the transformer’s core can use the laminated silicon steel sheet that is known as the E-I core. The battery is charged using the constant-current method by maintaining the charging current at a constant value. The functional test of the battery shows that by using 5-A constant current charging, the battery takes 80 minutes to its full condition from 50% capacity at the beginning.

Keywords: lithium-ion battery charger, battery electric vehicles, medium frequency full-bridge DC-DC converter, silicon steel-core transformer


Kata Kunci


alat pengisi muatan baterai lithium-ion; kendaraan listrik; full-bridge DC-DC converter; frekuensi menengah; transformator inti baja silikon

Teks Lengkap:

PDF

Referensi


Ahasan Habib, A. K. M., Hasan, M. K., Mahmud, M., Motakabber, S. M. A., Ibrahimya, M. I., & Islam, S. (2021). A review: Energy Storage System and Balancing Circuits for Electric Vehicle Application. IET Power Electronics, 14, 1 – 13.

Ahasan Habib, A. K. M., Motakabber, S. M. A., & Ibrahimy, M. I. (2019). A Comparative Study of Electrochemical Battery for Electric Vehicles Applications. IEEE Int. Conf. on Power, Electrical, and Electronics and Industrial Application, (pp. 43 – 47).

Ahmadian, A., Mohammadi-Ivatloo, B., & Elkamel, A. (2020). A Review on Plug-in Electric Vehicles: Introduction, Current Status, and Load Modeling Techniques. Journal of Modern Power Systems and Clean Energy, 8(3), 412–425.

Aziz, M., Marcellino, Y., Rizki, I. A., Ikhwanuddin, S. A., & Simatupang, J. W. (2020). Studi Analisis Perkembangan Teknologi dan Dukungan Pemerintah Indonesia Terkait Mobil Listrik. TESLA: Jurnal Teknik Elektro, UNTAR, 22(1), (pp. 45 – 55).

Baccouche, I., Manai, B., Jemmali, S., & Essoukri ben Amara, N. (2018). Implementation of An Improved Coulomb-counting Algorithm Based on A Piecewise SOC-OCV Relationship for SOC Estimation of Li-ion Battery. International Journal of Renewable Energy Research. 8(1), 178-187.

Balci, S., Sefa, I., & Bayram, M. B. (2014). Core Material Investigation of Medium-Frequency Power Transformers. 16th International Power Electronics and Motion Control Conference and Exposition, (pp. 861 – 866).

Chau, K. T. (2015). Electric Vehicle Machines and Drives: Design, Analysis and Application. Singapore: John Wiley & Sons, Inc.

Du, S. B. Y., Wang, G., & Bhattacharya, S. (2010). Design Considerations of High Voltage and High Frequency Transformer for Solid State Transformer Application. 36th Annual Conference on IEEE Industrial Electronics Society, (pp.1 – 6).

Feng, C., & Yang, X. (2019). Explosion Mechanism and Prevention of Lithium-ion Batteries. 2019 IEEE Sustainable Power and Energy Conference (iSPEC), (pp. 969-974).

Halim, A. A. B. A., Eid-Bayoumi, E. H., El-Khattam, W., & Ibrahim, A. M. (2022). Electric Vehicles: A Review of Their Components and Technologies. International Journal of Power Electronics and Drive Systems (IJPEDS), 13(4), 2041 – 2061.

Hoque, M. M., Hannan, M. A., Mohamed, A., & Ayob, A. (2017). Battery Charge Equalization Controller in Electric Vehicle Applications: A Review. Renewable and Sustainable Energy Reviews, Elsevier, 75(C), 1363–1385.

Huang, P., Mao, C., Wang, D., Wang, L., Duan, Y., Qiu, J., Xu, G., & Cai, H. (2017). Optimal Design and Implementation of High-voltage High-power Silicon Steel Core Medium Frequency Transformer. IEEE Trans. of Industrial Electronics, 64(6), 4391- 4401.

Kim, D. H., Kim, M. S., Nengroo, S. H., Kim, C. H., & Kim, H. J. (2019). LLC Resonant Converter for LEV (Light Electric Vehicle) Fast Chargers. Electronics, 8, 1 – 14.

Kong, L., Li, C., Jiang, J., & Pecht, M. G. (2018). Li-ion Battery Fire Hazards and Safety Strategies. Energies, 11(9), 1 – 11.

Kularatna, N. (2012). DC Power Supplies Power Management and Surge Protection for Power Electronic Systems. CRC Press.

McLyman, T. (2011). Transformer and Inductor Design Handbook. Fourth Edition. CRC Press.

Microsemi. (2014). SG1526/SG2536/SG3526, Regulating Pulse Width Modulator: Datasheet .

Mondal, N., Biswas, S. K., Sinha, S., & Deb, N. K. (2007). Selection of The Filter Capacitor for Power Supplies Using 1-phase Diode Rectifier. Proceeding of 7th International Conference on Power Electronics and Drive Systems, PEDS 2007, Bangkok, Thailand.

Nasar, S. A. (1987). Handbook of Electric Machines. New York: McGraw-Hill.

Pramanik, P. K. D., Sinhababu, N., Mukherjee, B., Padmanaban, S., Maity, A., Upadhyaya, B. K., Holm-Nielsen, J. B., & Choudhury, P. (2019). Power Consumption Analysis, Measurement, Management, and Issues: A State-of-the-art Review of Smartphone Battery and Energy Usage. IEEE Access, 7, 182113 - 182172.

Pressman, A. I., Billings, K., & Morey, T. (2009). Switching Power Supply Design. Third Edition. McGraw-Hill.

Rospawan, A., & Simatupang, J. W. (2021). Microcontroller-Based Lead-Acid Battery Balancing System for Electric Vehicle Applications. Jurnal Elektronika dan Telekomunikasi (JET), 21(2), (pp. 128 – 139).

Rusli, M. R., Mukhlisin, A., Raharjo, J., Yuniarto, M. N., Wikarta, A., & Haerudin, H. (2019). Design and Consideration of Off-board Lithium-ion Battery Charger for Electric Vehicle. Journal of Physics: Conference Series, 1517, (pp. 1 - 8).

Sanguesa, J. A., Torres, V., Garrido, P., & Marquez-Barja, J. M. (2021). A Review on Electric Vehicles: Technologies and Challenges. Smart Cities 4(1), 372 – 404.

Samsung SDI. (2011). Specification of Product: Lithium-ion Rechargeable Cell for Power Tools, Model INR18650-20R.

Sun, X., Li, Z., Wang, Z., & Li, C. (2020). Technology Development of Electric Vehicles: A Review. Energies, 13(1), 1 – 29.

Tempo.co. (2022). Mobil Listrik Tim UNRI Juara Dua IIMS Hybrid FRESC 2022, Lihat Speknya. Retrieved from https://otomotif.tempo.co/read/1581373/mobil-listrik-timunri-juara-dua-iims-hybrid-fresc-2022-lihat-speknya.

Toshiba. (2004). TLP250, Photocoupler GaAlAs Ired & Photo−IC: Datasheet.

Umanand, L., & Bhat, S. R. (2001). Design of Magnetic Components for Switched Mode Power Converters. Second Edition. New Delhi: New Age International.

Zhang, S., Zhang, C., Xiong, R., & Zhou, W. (2014). Study on the Optimal Charging Strategy for Lithium-Ion Batteries Used in Electric Vehicles. Energies, 7(10), 6783 - 6797.




DOI: https://doi.org/10.26760/elkomika.v11i4.1013

Refbacks

  • Saat ini tidak ada refbacks.


_______________________________________________________________________________________________________________________

ISSN (print) : 2338-8323 | ISSN (electronic) : 2459-9638

Publisher:

Department of Electrical Engineering Institut Teknologi Nasional Bandung

Address: 20th Building  Institut Teknologi Nasional Bandung PHH. Mustofa Street No. 23 Bandung 40124

Contact: +627272215 (ext. 206)

Email: jte.itenas@itenas.ac.id________________________________________________________________________________________________________________________


Free counters!

Web Analytics Made Easy - StatCounter

Statistic Journal

Jurnal ini terlisensi oleh Creative Commons Attribution-ShareAlike 4.0 International License.

Creative Commons License